Trying to level kitchen cabinets on an unlevel floor. I have 1x2's, or could also get shims to do this. What is the best way and how? I would think by just using the 1x2's and placing them under the cabinets, it would still be unlevel, so what am I missing? Leveling the 1x2's? Confused! Tried contacting a carpenter, but he hasn't called back yet and we need to get the countertop istalled. Thanks for your help!
You need to determine just how unlevel your floor is. Then you add shims to make up that difference. If you do not have a laser level you can do it with a 4' level. Determine the run of your cabinets meaning from end to end. That is the area that need to be level. If you have a straight 8' 2X4 lay it on the floor then place the 4' level on top. Raise what you think is the low end until the level indicates level. Measure that gap and that should be the thickness shim to use (more or less) You need some bevel cut shims to just fine tune. A piece of shoe molding or base should hide that elevation difference and the shims.
By placing the cabinets on 1X2 the only thing you are doing is raising the height of the cabinets. That is unless you are using small portions for the shims. Most floors unless it is an older home usually don't call for that much of a shim.
Some even attach the cabinets to themselves and then raise them in unison adding the shim thickness called for as you go down the line.This message has been edited. Last edited by: redoverfarm,
Find the high point first - the cabinet that sits here will fit directly on the floor. All other cabinets will be shimmed as needed. Set a level line off of the top of that first cabinet - this will be the top of every other cabinet in the kitchen.
If you don't have a laser level - a good excuse to buy one. Get one that is self leveling.
Definitely start at the high point of the floor. I've seen cabinet installers run into problems because they did not start there. Of course those were the same installers that took them 9 months to complete the installation -- so don't learn from them.
And you don't need to level the floor. Use shims of whatever will work (shims, pieces of plywood, 1x2) and shim up the cabinets to be level. Level cabinets mean a level countertop.This message has been edited. Last edited by: Re-mdlr,
Thanks! The 1x2's were for using for shims..my son is the one doing it..but also, I am wondering when we take the kitchen sink out and switch it around..I know we have to turn the water off first..but is that a fairly simple job to do a switch a roo with that? Or will it be difficult also..and I posted this question twice, cause I thought I may have posted it in the wrong place..thanks for letting me know!
Basically, it's not difficult, but that also depends on what sink you want to install -- such as a drop in sink or an undermount sink. And then it also depends on what your new countertop material is going to be. If you're having new countertops pro made, then having them do an attached sink is a good idea. Start by asking whoever is doing the countertops, they can help.
thanks Re-mdlr, got the cabinets from Lowes, and we are planning on using the same sink, the countertop also came from Lowes, they still have it there since the cabinets are not installed yet, I gave them the measurements for the sink, so hopefully it will just fit right in..it is a drop in sink, the material for the countertop, I can't remember what it is, but its not an expensive type, like quartz or anything like that, so like I said, hopefully it goes in ok. We won't be doing it for awhile..probably a week or so. Thanks again!This message has been edited. Last edited by: xsil11,
For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.