I saw a platform bed online and instantly liked it. My search both online and in stores did not help.
Here is the picture.
Is there any way I could make it myself. I went to my local home depot and the wood there wasn't smooth. I also don't want to mess up my sleeping place. Any help would be great!This message has been edited. Last edited by: Jayasimhan,
the wood was not smooth !! that why they make and sell sandpaper .
The bed is made from all 1x material - 1x8, 1x6 and some 1x4. You'll want to buy a clear grade - for the look of the one in the picture it will be poplar or perhaps a clear #1 pine.
The clear grades of 1x are reasonably smooth - they are sold at what's called s4s, meaning that all four sides are planed smooth. You'll still have to sand edges and any cuts but the main surface of wood of this grade will just need a light sanding.
You'll also need some screws and glue and a clear poly to seal everything. You are looking at about $150 in wood costs, with another $20 in glue and screws. You'll need a saw for cross cuts (ideally a circular saw), a jig saw for those rounded corners, a drill for driving screws and pre-drilling holes and a brush to apply the sealer.
All in all a fairly easy project for even a beginning DIYer.This message has been edited. Last edited by: Jaybee,
Jaybees reply was spot on. and I'll add some shortcuts to make the job even easier
After you cut all the parts, but before you sand and finish them, dry fit them, including the screws.
Mark every place where you intend to glue and mark each pieces location in relation to each other.
Disassemble , and sand and finish each piece except where the glue will go
When everything is dry and finished to your satisfaction, glue and reassemble, making sure that each piece is where you marked it. this will make putting in the screws easier
Get your mattress and take a nap
Good job , well done
That's a bed?
Looks like a torture device to me.
If you do not have a bad back now you soon will after laying on that bed.
For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.