DIY Message Boards
Stairs: Joining Risers and Treads

This topic can be found at:
http://boards.diynetwork.com/eve/forums/a/tpc/f/8491013504/m/7823904287

Dec 19, 2013, 01:11 PM
althor43
Stairs: Joining Risers and Treads
I'm installing hardwood risers and treads on what was originally carpeted stairs. The bottom half of the stairs have one side against the wall and the other side is open. I'm trying to make the open side look good.

I think that leaving the sides of the risers and treads flat looks like crap, so I want to use a router to round them off before stain/poly. My question is, how do I cut (route) the edges so that there isn't a gap where the two boards join up? I don't see any way to join the two boards that doesn't look ugly...
Dec 19, 2013, 03:38 PM
Jaybee
Risers are usually flush with the wall surface and are covered with trim. Treads overhang the wall surface and extend back past the riser. You can either get treads that are rounded on the ends or you can buy rounded trim end pieces.

Invest in a good trim book and take a look at some of the pictures. Building a staircase is a complex process that takes time and skill. We are currently working on a stair and rail project that costs out a little over $30K.


Jaybee