DIY Message Boards
Counters

This topic can be found at:
http://boards.diynetwork.com/eve/forums/a/tpc/f/8091013504/m/9373910577

Nov 05, 2013, 03:00 AM
Addiesdaddy
Counters
Home renovation/ countertops?
My wife is painting out laminate countertops since I won't buy her granite. The thing is that the edges of the laminate counters are tile. She doesn't want the tile. I can take that off fine. But she wants me to change the edges from a plain square edge to something called a waterfall edge and Then laminate the edges. So first question: how do you laminate a waterfall edged counter.
Second question: how can you make a square edge into a waterfall edge? Sand it? I know this is probably confusing. I just need some help with this.


Thomas ellis
Nov 05, 2013, 05:19 AM
thomashenry
Dude this is not happening just buy
Her the granite or at least granite
Looking laminate. It will save your
Marriage.
Nov 05, 2013, 06:11 AM
Addiesdaddy
My wife told me to tell you that your a smart man. Haha


Thomas ellis
Nov 05, 2013, 09:18 AM
Sparky617
If your kitchen has simple runs, straight counters or one corner look at post form counters at your local home center. They have about 5 or 6 stock designs including a couple granite patterns.

Post form has a single piece of laminate from the bottom of the front edge to the top of the backsplash at the wall. All of the edges are rounded with the exception of the ends.

You can't reshape the edge of an existing laminate counter with a laminate edge. The laminate is quite thin and the color generally doesn't go all the way through the product.

Post form counters can be done for a couple of hundred dollars and are very DIY friendly if you have moderate DIY skills. The next step up is building your own counters with sheet laminate. It isn't hard, but requires some tools and experience using them.

Here is an article on making laminate counters and setting post form counters. http://www.hometime.com/Howto/...itchen/kitchen_6.htm


General Disclaimer

Any advice given here is general in nature and is not necessarily valid for your given area. If in doubt check with your local codes enforcement department for what is required when doing electrical, plumbing or structural work on your house. Permits may or may not be required in your area and home owners may not be able to DIY some tasks. I have no way of knowing if you have the skills needed to complete the tasks you are asking about, when in doubt seek professional assistance.

My advice may be worth exactly what you pay me for it. :-) For the record I did not stay in a Holiday Inn Express last night.
Nov 05, 2013, 11:10 AM
GardenSprite
Addiesdaddy, ThomasHenry is a troll, some of whose comments have previously been removed by the moderators because of the hostility expressed and snide remarks toward other posters.

Don't take him/her/it seriously.... Just a warning to watch out for trolls like TH.
Nov 06, 2013, 11:48 AM
swschrad
"waterfall" countertops are simply running the same granite down the side of the cabinets. the top edge covers the vertical side, so the material looks like Dali installed it, and it just melted down.

to do this with laminate, you install the laminate on the cabinet side first and trim it off with a trimmer bit so it's flush with the top. the fun part is putting all the dowels up vertically, I would think, so it doesn't stick to the contact cement kittywompus and look nasty forevermore.

then you glue on the countertop and trim that flush. here you use your plenty 'o' dowels in a more stable mode to keep pockets from drooping and sticking in a never-fixable state with humps and rolls in the laminate.

not sure how you're going to like this, but it's your place, and with the right material (NOT classic boomerangs!) it might look nice.

warning, danger, fattening department: the contact cement will get the sink goofy, and your liver won't like it 10 or 20 years down the road. have a ton of good cross-ventilation going.


sig: if this is a new economy, how come they still want my old-fashioned money?
Nov 08, 2013, 07:25 PM
Wildlife Artist
Hi guys, I am new here, in fact, this is my first post on this forum.
The reason for my visit, is to PLEASE find any info on James Young's "Agate Bar" counter top he made in his show entitled "Loft in the Burbs"
What I need, is info on HOW he mixed the resins, WHAT he used for a form, and WHERE he got the boxes of gorgeous agates.
He had his counter lit from below, I may or may not be into that.....but please anyone with any info I need to know, PLEASE shoot me a message!
Thanks ahead of time !
Nov 09, 2013, 01:16 PM
1wildfire
Hello everybody, I'am trying to find out what wall color would go good in my kitchen, I have knotty pine ceilings, n was thinking out putting wood look on kitchen floor, n I have wood brown cabinets, but some are in this darkest walnut color n the doors are got brown contact paper on doors, yaky, so how can i change the dark walnut color , n the counter top is this brown wood look like stuff that i beleieve is venear, So my new colors I want is red, black, white, copper, n chrome, are going to be my new accent colors, I only have 1 wall to paint because behind my counter n stove n sink I want to bring the back slapsh all the way around, I thought of a nice white for the wall n I also thought a warm color, now if thiers away to make the kitchen have some what of a rustic look with this colors that cool to, but I dont want any green in my kitchen n no blue if at all possible
Nov 10, 2013, 01:22 AM
Jaybee
A quick note to our new posters: You will have better results to your questions if you start a new topic. Both the above new posts are far enough off the original topic that not everyone who could help you will find your posts.

Just pick the appropriate section and hit the 'new topic' section.


Jaybee
Nov 19, 2013, 12:00 PM
Mike8918
If your not gonna get her granite counter-tops you should buy her granite cabinet knobs. They only cost a couple dollars.