Feb 20, 2013, 09:06 PMTravis2897
Finding awkward angles
Went to help a friend install shoe moulding . There are a couple of angles that we can't figure out. We tried cutting it at 15 degrees. And working our way up the different degrees . And can't find it. Any suggestions ?
Feb 20, 2013, 10:10 PMredoverfarm
Ned to use a "slidding bevel square" You can set it to the angle that you are after and then transfer to match up to a saw.http://www.google.com/shopping...DoCw&ved=0CFcQ8wIwAA
Feb 21, 2013, 07:58 AMjoecaption
That will work but I prefure using one of these.http://www.amazon.com/Starrett...ords=starrett+505p-7
It will instantly give me the exact angle to set the saw for a single or a double cut.
If you take the time to cope that moulding there will be no gaps that need filling.
Feb 24, 2013, 10:11 PMswschrad
from the Quick and Dirty department... put a piece of scrap wood along the long side. put another over it along the short side. mark the angle on the bottom board with a pencil. cut and transfer to the final material.