DIY Network

All Projects

TV Projects

    What Do You Want To Work On?

      What Activity Do You Want To Do?


        Available Projects

        Get Results

        DIY Network /

        Message Boards

            DIY Message Boards  Hop To Forum Categories  Home Improvement  Hop To Forums  Bathroom    Swanstone shower base install question
        Swanstone shower base install question Sign In/Join 

        We are re-modelling a shower unit and have ripped out the old shower unit, installed a new shower valve and put in a Swanstone shower pan base (36" x 36") and attached it to the drain (well actually we paid a plumber to do this work). We want to hang some hardiebacker board then tile & grout. The floor under the base is flat and solid and the base is pretty snug up against the rear wood frame and has about a 1/4" gap down either side. The plumber did not secure the base to the floor with mortar. My questions are:

        1) What can I do to secure the base to the side & rear wood frame. Swanstone says not to fasten the base flange using nails or screws but they say its optional to knock in a roofing nail at an angle and have the nail head secure the base.
        2) Swanstone recommends a 1/2" gap between the bottom of the backer board and the top of the flange. The flange is about 1.5" high so that gives a 2" gap between the backer board and the lip of the shower base. We want to add tile cement and tiles on top of the backer board all the way down to the base lip so what do we do with this bottom 2" where there is no backer board?
        3) The backer board is 1/2" thick and in the rear it is not flush with the side of the base flange as the flange is only 1/4" wide. I tried moving the base forward a 1/4" but it won't budge. Is this going to be a problem or can I just add extra tile cement to the back of the tile to make up for the 1/4"?

        Posts: 1 | Registered: Jul 10, 2013Reply With QuoteReport This Post
        Picture of Frodo
        posted Hide Post
        you do not need to secure it to anything, if its vevel oit will sit right there and the tile,rock gravty weill hold it in place
        drop[ thee rock down to 1/2" above the pan, then when you tile, drop the tile down that 1/2' TO COVER THE JOINT. CAULK THE JOINT key stuck,,,

        This message has been edited. Last edited by: Frodo,

        Posts: 3843 | Location: I live in southern mississippi | Registered: Jun 01, 2008Reply With QuoteReport This Post
          Powered by Social Strata  

            DIY Message Boards  Hop To Forum Categories  Home Improvement  Hop To Forums  Bathroom    Swanstone shower base install question

        © Scripps Networks 2009


        Posting Guidelines

        • Please be sure posts are category appropriate.
        • No off-topic or off-color postings.
        • Postings may be deleted at the discretion of DIY moderators.
        • No advertising is allowed.
        • Be nice. No name calling, personal attacks or flaming.
        • Certain words will trigger moderation of the post. These words mostly cover political or religious topics, which are OFF the topics covered by DIY.

        Full Guidelines

        For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.