Yes, about halfway along the shaft, on the underside. Can this little hole be soldered or otherwise plugged, or should I just replace the thing?
Thanks for any wisdom and/or advice.
Got a picture?
If your talking about the spout from the base of the fixture to where the water comes out, time for a whole new faucet.
Can't imagine how that happened unless it's a fairly inexpensive faucet to begin with and was very thin.
Best fix would be to replace but odds are a tiny spot of JB weld (No - I don't make the stuff) would likely fill the hole.
and the next pinhole, and the next, and the next...
it's time to replace the fixture.
sig: if this is a new economy, how come they still want my old-fashioned money?
For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.