DIY Network

All Projects

TV Projects

    What Do You Want To Work On?

      What Activity Do You Want To Do?

        0

        Available Projects

        Get Results

        DIY Network /

        Message Boards

            DIY Message Boards  Hop To Forum Categories  Home Improvement  Hop To Forums  Plumbing    Sink Drain Installation
        Go
        New
        Find
        Notify
        Tools
        Reply
          
        Sink Drain Installation Sign In/Join 
        posted
        Hi all,

        I recently had a new porcelain sink installed. Unfortunately, the folks installing it did not re-install the drain, so I am left to complete this task. The components I am dealing with can be seen here.

        Being completely new to plumbing, I did some googling and watched a number of YouTube videos on the topic. Here's what I'm struggling with:


        • Should I apply plumber's putty, thread seal tape, or both to the pipes?
          - Both of the videos I saw on YouTube suggested to apply both. When I picked up some putty at HomeDepot, they suggested I don't use it, because according to them, it is fairly permanent. Help?
          -- If either one is to be applied, where along the pipe(s) do I apply it? I have marked up one of the pictures to indicate where I would apply the thread seal tape. Would appreciate any feedback.

        • How do I prevent water from leaking into the sink?
          --> As you can see in the second picture at the link I posted above, my sink has a hole. Unless my senses are failing me, if I install the drain, water is going to end up shooting into this hole from the hole in the drain pipe (see red highlighted area in the picture of the drain pipe). Can anybody explain the function of this hole to me and what will happen here?


        Thanks for your help!

        This message has been edited. Last edited by: skyfx,
         
        Posts: 2 | Registered: Jun 03, 2013Reply With QuoteReport This Post
        posted Hide Post
        Yes, use putty under the flange. There is no need for the Teflon tape, but others might disagree. There is often more than one way to do things. Where your picture shows the upper tape, I have never seen a leak from there. Where your picture shows the lower tape, you'll probably damage it as you move the rubber gasket up into place. If you have a leak there, tighten the nut against the rubber gasket. With a new sink, I'd be looking to install a new drain also, with new gaskets and finishes.

        The hole you are talking about is the overflow drain. How does it work -- it just sits there, gravity works, the water drains out. It will be clear once you start installing it all.

        Give it your best shot to put it together, watch for leaks. If it does leak then you can pull it apart and try again. It's really not difficult, and kind of fool proof. It's a standard system that has been used for years.

        This message has been edited. Last edited by: Re-mdlr,
         
        Posts: 868 | Location: No. California | Registered: Mar 24, 2004Reply With QuoteReport This Post
        Picture of CommonwealthSparky
        posted Hide Post
        While the folks at big box stores try to provide accurate information, relying on that advise they know is usually very little help. Follow Re-mdlr post and you will be fine.


        Popeye only reached for the Spinach can as a last resort...
         
        Posts: 1391 | Location: Central Pennsylvania | Registered: Jun 02, 2010Reply With QuoteReport This Post
          Powered by Social Strata  
         

            DIY Message Boards  Hop To Forum Categories  Home Improvement  Hop To Forums  Plumbing    Sink Drain Installation

        © Scripps Networks 2009

        Advertisement

        Posting Guidelines

        • Please be sure posts are category appropriate.
        • No off-topic or off-color postings.
        • Postings may be deleted at the discretion of DIY moderators.
        • No advertising is allowed.
        • Be nice. No name calling, personal attacks or flaming.
        • Certain words will trigger moderation of the post. These words mostly cover political or religious topics, which are OFF the topics covered by DIY.

        Full Guidelines

        For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.