hi everybody hope all had good turkey day my problem is that 3/4 of my concrete septic tank lid has fallen into tank where do i find a relacement i would prefer some thing def from concrete if possible thanks
drove over it did ya?
2 choices i see, call a septic compnany and get them to winch out the old and replace with new
or, do it your self,,,rent a 4" mud pump, pump the tank dry, get the old out.
build a form for a new one using timbers or blocks to hold it up till poured, after it cures, knock out the timbers
install you of these in your new lid, doesnt have to be this one, but a man hole is nice for maintaince
ck local plumbing store..
i have seen plywood used for lids, corgated metal, pallets with a tarp. you name it. if you do it right, no problems latterThis message has been edited. Last edited by: Frodo,
I'd just make a new one out of concrete. It would take a bag or two of concrete mix, a couple of pieces of 2' rebar, and some forms made from 2x4's. Depending on the size you might be able to get by with a 2x2 concrete patio tile.
As far as getting the broken piece out, that it a job for the next time the tank is pumped out. Which now might be a good time to do it anyway. DIY pumping not recommended and very likely illegal. You need to be licensed to do it, and have a tank to pump it into and the ability to haul said tank to a licensed disposal area, typically a sewage treatment plant.
Any advice given here is general in nature and is not necessarily valid for your given area. If in doubt check with your local codes enforcement department for what is required when doing electrical, plumbing or structural work on your house. Permits may or may not be required in your area and home owners may not be able to DIY some tasks. I have no way of knowing if you have the skills needed to complete the tasks you are asking about, when in doubt seek professional assistance.
My advice may be worth exactly what you pay me for it. :-) For the record I did not stay in a Holiday Inn Express last night.
I think whatever we advise here depends on the phrase "3/4 of my septic tank lid" and what it actually means. Could be the 2' x 2' access hatch or it could be the entire top lid.
I'm betting on the entire lid as anything that would take out the either part of the top of the tank would need to be something big like a vehicle.
But, until grandpa verifies, hard to say what to do.
grandpa.....you gonna let us know how your lid is? mine is 8'x6' x4" thick
i use a back hoe to move it around
need a man hole init,,,oh well add it to the listThis message has been edited. Last edited by: Frodo,
hi thanks for response the whole top of tank gave way tank 30 yrs ol
For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.