Hi fellow DIY-ers!
Are there any tips/requirements for adding length to a bearing wall? I would like to extent a bathroom about 3 feet but one wall is bearing. The perpendicular wall (non-bearing) will also now house a pocket door.
Are you adding length to the load bearing wall, adding a perpendicular wall to the wall or what? I'm not quite following your post. Could you do a quick drawing of what you want and attach it to a follow up post?
Any advice given here is general in nature and is not necessarily valid for your given area. If in doubt check with your local codes enforcement department for what is required when doing electrical, plumbing or structural work on your house. Permits may or may not be required in your area and home owners may not be able to DIY some tasks. I have no way of knowing if you have the skills needed to complete the tasks you are asking about, when in doubt seek professional assistance.
My advice may be worth exactly what you pay me for it. :-) For the record I did not stay in a Holiday Inn Express last night.
If you are adding length to a wall, then you are just installing a non-load-bearing element to the house. Load bearing is only an issue if you are taking out all or part of a load bearing wall.
Thanks Jaybee and Sparky617.
On further investigation I am not so convinced the wall I referenced is bearing. It's only 6 feet from the exterior wall. Trusses overhead run perpendicular to the wall I was referencing extending, and parallel to the wall I want to mnove. The area the roof covers overhead is approx 17' wide. Hard to believe the 3' wall I'd like to move would be bearing either.
I have to look at a FAQ ti find out how to get an image here. All the ones I scanned were far too large.
How are you trying to load photos? Directly through this site or through an off-site storage such as Photobucket?
You might try this: Click on "New" in the toolbar, then Photo Album, then follow the instructions from there.
You will have to reduce your photo, but offhand I don't know the size limitations. They may be stated somewhere here.
I just tried to upload a 565KB photo, without any problem.
There are some good instructions on loading to an offsite album, but they're in another older post and right now I don't have the link. I'll post it if I can find it.
thanks for the tip. I scanned a hand-drawn picture, but now it's too big (2MB max). will try a photo later today.
Do you have any photo editing software, ranging from more high end such as Photoshop to just basic Paint? You could try reducing your sketch in this kind of program.
Thanks for the support all. I had a structural engineer come by to take a look. No bearing wall in play! Let the fun begin!
BTW - I loaded a bunch of pictures and somehow they didn't make it here.
For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.